About sei outboard lower units
Wiki Article
Plenty of people check for water when shifting out the gear oil. They will drain the oil, check for water, then replace the oil.
When the pressure continues to be constant, it indicates the lower unit is adequately sealed, and no main problems are existing. Nonetheless, if pressure drops, it implies a potential difficulty, and additional inspection and repairs may very well be needed.
The process aims to satisfy or exceed field standards, delivering a tough and substantial-general performance remanufactured lower unit
Our determination to individualized service guarantees that your unit will access you with exact specifications, optimizing your boat’s efficiency.
Should you detect pressure dropping, listen for air hissing, which can enable pinpoint the location of the leak.
Now that you are aware of all about pressure testing your gearcase! Here are several other articles or blog posts that we have composed that you will obtain truly helpful and informational!
We try this by supplying good quality service, knowledge and energy. We provide the best boat repair service department from the Kansas Metropolis area. Demand your appointment now.
Why select a remanufactured lower unit above a different a person? Picking a remanufactured lower unit provides important cost discounts though being eco-friendly in the recycling of used parts.
Now install the pressure tester in the best vent screw hole and pump up to 10-12 PSI. Spray soapy water across the seals in the drive, shift, and prop shaft. Inspect for bubbles indicating a leak.
It’s critically vital that you often Verify the gearcase on your drive and prop shafts for water intrusion. If water has gotten inside of, it most probably signifies You will find there's degraded seal (or seals) that will need to be replaced.
Prior to conducting a lower unit pressure test, it’s highly recommended to familiarize oneself with the precise demands of one's outboard motor’s make and model, as being the tools and adapters required will get more info vary.
Just appear your gear case over and locate the drain and vent screws. Then the method as well as the pressures will be the same as carrying out it on an outboard.
In addition to the adapter, and voila! You’ve bought oneself a lower unit pressure tester! Just pressure test your gear case, take care of your problem therefore you are good to go!
Trustindex verifies that the original supply of the review is Google. I have made some buys from these men and I'm really amazed with their familiarity with boat and boat motor parts.